<div dir="auto">I checked the two four jaw chucks. They both have the same four bolt pattern style. The spacing is ~4.12" on one and ~2.81" on the other. I have attached a picture of the bigger one. <div dir="auto"><br></div><div dir="auto"><br></div></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Wed, Mar 13, 2024, 6:55 PM Denis Muradov <<a href="mailto:denis.muradov@gmail.com">denis.muradov@gmail.com</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><div dir="auto">We have two four jaw chucks with nothing on the back. I think they have plain backs? I will double check.</div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Wed, Mar 13, 2024, 5:13 PM John P Anthes <<a href="mailto:jpanthes@comcast.net" target="_blank" rel="noreferrer">jpanthes@comcast.net</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">Wow! Sure am glad you learned of this situation Denis.<br>
Honestly, I cannot imagine how this happened?<br>
<br>
Untrained users?<br>
<br>
I’ve spoken a few time of a 4-jaw chuck. But we never located one? I do rather recall having one at sometime?<br>
And I don’t recall a collet chuck available that would substitute for the 3-jaw chuck?<br>
<br>
I just don’t get it. But and pleased that you discovered the concern.<br>
THANK YOU!<br>
<br>
John Anthes<br>
Sent from John's IPad Air<br>
<br>
> On Mar 13, 2024, at 6:28 PM, Denis Muradov via Machineshop <<a href="mailto:machineshop@quelab.net" rel="noreferrer noreferrer" target="_blank">machineshop@quelab.net</a>> wrote:<br>
> <br>
> <br>
> Today while, Mr Ford was working on the backlash problem, I decided to take the chuck off. It turned out that the camlock position screws were in the open position, except maybe for one which was halfway. This could have caused the chuck to come off during operation. This might explain the parallelism issue some users ran in to during training. <br>
> <br>
> From now on, whenever using the lathe, double check that the camlock screws are in the locked position. Take a look at the picture for the correct orientation. More permanent labeling will need to be done in the future.<br>
> <br>
> I will update the training documentation with this step in the future. <br>
> <br>
> Thanks<br>
> --<br>
> Machineshop mailing list<br>
> <a href="mailto:Machineshop@quelab.net" rel="noreferrer noreferrer" target="_blank">Machineshop@quelab.net</a><br>
> <a href="http://pepper.quelab.net/mailman/listinfo/machineshop" rel="noreferrer noreferrer noreferrer" target="_blank">http://pepper.quelab.net/mailman/listinfo/machineshop</a><br>
</blockquote></div>
</blockquote></div>