<div dir="auto">Today while, Mr Ford was working on the backlash problem, I decided to take the chuck off. It turned out that the camlock position screws were in the open position, except maybe for one which was halfway. This could have caused the chuck to come off during operation. This might explain the parallelism issue some users ran in to during training. <div dir="auto"><br></div><div dir="auto">From now on, whenever using the lathe, double check that the camlock screws are in the locked position. Take a look at the picture for the correct orientation. More permanent labeling will need to be done in the future.</div><div dir="auto"><br></div><div dir="auto">I will update the training documentation with this step in the future. </div><div dir="auto"><br></div><div dir="auto">Thanks</div></div>