[QUELAB CNC] test message

[Ray Finch]

A plasma cutter would awesome!

I know about motion control (stepper motors, controllers, software etc.). 
I'm somewhat limited on time these days, but I can help out with the 
electronic details for either project.

--Ray

On Sun, 5 Sep 2021, Adric wrote:

> Whom else is on this list?    and who's going to take points on the cnc build.  looks like there may be a planto put this cnc where the shapeoko was,  (moving the
> flammables cabinet over to where some of the lockers are, once the locker bank gets shortened. 
> At the same time it looks like we may be getting a small water table plasma cnc that may be small enough to fit in the welding shop (and there is even water access
> there,,  more details when things get finalized.   This will be a loan to quelab and will probably go away in 1-2 years but hopefully we can find the pluses and
> minuses of this setup to better select what we replace it with if its popular. 
> 
> On Sun, Sep 5, 2021 at 1:58 PM John Benedetto <john.benedetto at gmail.com> wrote:
>       this is a test message to the CNC list to see if I remembered the address correctly and if all still works as it should!
> _______________________________________________
> CNC mailing list
> CNC at quelab.net
> http://pepper.quelab.net/mailman/listinfo/cnc
> 
> 
>